Caution
High center of gravity. Make sure that the cabinet does not fall over.
Notice
The maximum tilting angle of the charging power unit is 6 degrees.
Notice
One cabinet with four Power Modules weighs approximately 400 kg. Use appropriate lifting equipment, e.g. a forklift, operated by qualified professionals.
Notice
A single Power Unit, Power Cabinet Version 4 without Power Modules weighs approximately 381 kg. Fully loaded with Power Modules the single cabinet weighs approximately 541 kg. Use appropriate lifting equipment, e.g. a forklift, operated by qualified professionals.
Note
Fastening hardware for installing the units to the installation surface is not included in the Kempower delivery.
Note
For information on Kempower DC charging points, see Kempower user manuals, available at Kempower Mediabank.
Inspect the delivery as soon as possible. If the equipment is damaged, do not start the installation. For assistance, contact Kempower Technical Support.
Power Unit is shipped upright on a pallet and wrapped in plastic. The top of the unit is covered with a cardboard cover.
Power Unit, Power Cabinet Version 4: Make sure to remove each of the cabinet's four fixing screws to remove the unit from the pallet.
Power Unit, Power Cabinet Version 3 and earlier: Make sure to remove the fixing brackets to remove the unit from the pallet.
For Power Module Version 2, remove the protective sticker from the extra ventilation holes before installing the module. See Figure 7, “Protective sticker for Power Module Version 2 ventilation holes”.
Power Unit shipments have a tilt indicator. If the tilt indicator indicates mishandling, do not start the installation. For assistance, contact Kempower Technical Support. Remove the tilt indicator before you start the mechanical installation.
Make sure that you have the required tools and equipment on site for the delivery and installation, including appropriate lifting equipment e.g. a forklift.